Ouellet OAF - Manual (Page 3)

3
MAINTENANCE
Read complete instruction before proceeding. Under normal use, cleaning the Dryer once a year will keep it in
good operating condition. If the washroom traffic is heavier than normal, the cleaning should be done every 6
months. Lint and dust build up inside the dryer can result in damage to motor.
CLEANING INSTRUCTIONS
1. Disconnect the electrical supply.
2. Turn clockwise two cover mounting screws from dryer cover using security hex key provided. Support cover
while removing screws.
3. Vacuum out dirt from blower and housing. Use caution not to damage wires or circuit boards.
4. The motor inlet cover may be removed by unscrewing the (4) screws. This allows access to the motor for
cleaning or replacement.
5. Use soft‐medium bristle ½” paint brush to clean dust and dirt from motor.
6. Replace cover. Place cover squarely over base and push flush to wall. Turn cover mounting screws counter‐
clockwise and tighten until snug. Do not over tighten.
Table 1
RECOMMENDED MOUNTING HEIGHTS FROM FLOOR TO DRYER BOTTOM EDGE
in. cm.
Men’s washrooms 46 117
Women’s washrooms 44 112
Children’s washrooms, ages 4‐7 32 81
Children’s washrooms, ages 7‐10 36 91
Children’s washrooms, ages 10‐13 40 102
Children’s washrooms, ages 13‐17 44 112
Handicap Mounting Height 37 94
Table 2
TYPE OF WALL
TYPE OF BOLT MINIMUM BOLT LENGTH
Hollow tile, lath, wall board or
metal ¼” (M6) screw type or Wing type toggle
bolts
Dependent on wall thickness
Cement, brick, or tile covered
cement or brick
¼” (M6) stud type expansion bolts 3” (76 mm)
Stud wall with wood backing No 16 (M8) wood screws 2 ¾” (70 mm)