Ouellet UFO-E - Manual (Page 6)

ENGLISH
UFO user manual 4
3. INSTALLATION INSTRUCTIONS
3.1 Installation Instructions
Attention! The appliance must be installed at level on solid surfaces. See pages 4-7 to come up with
the most appropriate installation method for your UFO.
1. Drill four 8 mm (5/16’’) diameter holes on the wall to the place where the unit will be placed with
the distances shown in (Figure-1)
2. Insert the wall anchors supplied with the unit into the holes.
3. With a star (Phillips) screwdriver, mount two of the L shaped legs on the wall using the #5x1.5’’
screws supplied with the unit.
4. Mount the other L legs on the unit using the six #M5x6 screws and the small wrench as shown in
(Figure-2) (corresponding nuts are already built in on the body of the unit).
5. Mount and fix the L shape legs on the wall and on the unit respectively, using the #M8x15 bolts
and #M8 nuts and the washers as shown in (Figure-3) and tighten by using the wrench supplied.
6. Depending on the area to be heated the angle of the unit can be adjusted between 0-45 degrees
by the help of #M8 bakelite head bolt and nut fixture (Figure-4).
7. Before operating the unit, check the installation solidity once again.
Figure 1 Figure 3
Figure 2
Figure 4