Ouellet UFO-E - Manual (Page 17)

ENGLISH
UFO user manual 15
6.2.4 Control through the main module on the heater
The button on the left functions as ON / OFF. « H0 » indicator appears on the screen when the heater
is switched ON and it is in stand by mode. (The 1 st digit on the screen illustrates H symbol while 2 nd
digit illustrates power level mode from 1 to 5).
Press the right button on the heater to adjust power mode from 1 to 5 (H1, H2, H3, H4 and H5).
Note: The heater starts operating at the power level mode at which it has been switched off.
Press ON / OFF button on the remote control or the heater itself to switch off the heater.
If the radiator is tilted at an angle greater than 5°, it will refuse to operate and a buzzer will sound. The
message « Er » will be displayed. If the radiator is tilted at an angle of more than 5° when in function,
it will stop working and a beep will sound. The message « Er » will be displayed. In these two cases,
to operate the unit again, disconnect / reconnect the heater and put it back in a horizontal position.
The heater starts functioning in stand by mode after a power outage.
LED keeps flashing in case of a program set by remote control.
Buzzer signal is given following each command.
LED
Power level
On/OFF Power mode
H