Ouellet OVN - Manual (Page 2)

INSTALLATION INSTRUCTION
SURFACE WALL MOUNTING STEPS
without removing the front cover
1. Use the template provided with the heater.
Allow 4 in. (102 mm) minimum below heater.
Recommended installation height is 12 in. (305 mm)
below the heater for a better temperature regulation.
Locate positionning of the supply wire
and make a 1 in. (25 mm) diameter hole.
Firmly install the 4 screws supplied to the wall.
DO NOT OVERTIGHT SINCE YOU WILL NEED
TO SLIDE THE HEATER AT STEP 3.
2. For an installation with “Loomex” fl exible wire,
use the single-screw wire holder by unscrewing the screw,
make the connections and screw back the wire holder.
Do not let more than 12 in. (305 mm) of loose wire
between the heater and the wall.
For an installation with “BX” cable, follow step 4. b)
of the RECESSED WALL MOUNTING STEPS or
SURFACE WALL MOUNTING STEPS by removing the
front cover.
3. Align the oversized part of the holes with the screws
already on the wall, then slide the heater downward.
Make sure that the 4 screws are well supported at the top
of the keyhole (small part).
4. Once the heater in place, fi nish tightening the 4 screws with
a 5 in. (127 mm) minimum rod screwdriver through the
grilles of the heater as shown. DO NOT USE
A DRILL WITH A SQUARE BIT AT THIS STEP
BECAUSE YOU COULD DAMAGE THE GRILLES.
5. Test the heater by pressing the “Hour-glass” button
to activate the boost heating mode. It is possible that a slight
heating smell emerges from the grilles, which is totally
normal and will stop after a few minutes of operation.
1.
2.
3.
4.
4.
Template provided
Figure of Surface wall mounting installation without removing the front cover