Ouellet OVB-LN - Manual (Page 9)

2
Dear customers,
Thank you for selecting Aero Pure, which is surely to bring you satisfaction. Read all
instructions before using the unit. Save these instructions please.
1. Use the unit only in the manner intended by the manufacturer. If you have questions,
contact the local agent or the manufacturer.
2. Before servicing or cleaning the unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by qualified person(s) in accordance
with all applicable codes and standards, including fire-rated construction.
4. For the purpose of avoiding any dangerous gas leaking into your house, the duct must
not be laid together with the vent-pipe of air-fueled water heater into the same flue.
5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. NEVER place a switch where it can be reached from a tub or shower. To reduce electric
troubles, water must be prevented from going into the housing. The fan must not be
installed at the place where suffers severe water leakage.
8. Not for use in the cooking area (Figure 1).
9. Not for use in the shower cubicle generally.
10. The ceiling must be strong enough to support
the weight of the fan.
11. The fan must be properly grounded.
12. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock, or damage the unit.
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
13. Do not block air intakes or exhaust in any manner.
14. Do not switch on/off frequently when in use. Shut off power if in long vacancy.
15. Shut off power urgently if anything unusual occur when in operation and contact with local
agent or specialized maintenance shop.
16. When clean the fan, do not use corrosive chemical liquid. Do not rinse plastic parts in
water the temperature of which is higher than 60 .
17. For supply connections use No. 14 AWG or larger wires suitable for at least 90 (194 ).
18. Do not use outdoors.
19. To reduce the risk of fire, use only PL type 26W lamp. For the nightlight use a maximum
4W lamp. (Model: AP80L1, AP80L2, AP80L3, AP100L1, AP100L2, AP100L3)
20. Ceiling Insert Fans must not be installed in a ceiling with an insulation value that is greater
than R40.
21. TYPE IC-INHERENTLY PROTECTED.
22. To reduce the risk of injury to persons, install fan at least 2.1m (7 feet) above the floor.
23. These fans (model number is: #L1, #G2, #G6) are acceptable for use over a bathtub or
shower when installed in a GFCI protected branch circuit. Other models are not for use over
a tub or shower.
1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials
and vapors.
2. This product is designed for installation in flat ceilings only and for household use only. Do
not mount it on a sloping ceiling or a vertical wall.
3. To avoid motor bearing damage and unusual noise and/or unbalanced impellers, keep
drywall spray, construction dust, etc. off the unit.
4. It is highly recommended to make preparation for unit installation when you retrofit your
bathroom.
5. Please read specification label on product for further information and requirements.
CAUTION
SAVE THESE INSTRUCTIONS
Figure 1
Floor
Cooking
Equipment
Cooking area
Do not install above
or inside this area
45 45
READ AND SAVE THESE INSTRUCTIONS.
Read these instructions carefully before installing or using this product!
o c
o c o c