Ouellet OHY User Manual

Page 4

180, 3

Avenue, LʼIslet (Québec) G0R 2C0 CANADA

Telephone: (418) 247-3947, 1 800 463-7043

Fax: (418) 247-7801

www.ouellet.com

INSTALLATION INSTRUCTIONS

FOR CAST TRIM SLEEVE OHY-CM OPTION

RISK OF ELECTRIC SHOCK

WARNING

Read Carefully - These instructions contain necessary

information for the proper installation, use and efficient

operation of the heater. Carefully read these instructions

before installation, operation of the heater. Failure to

adhere to the instructions could result in fire, electric

shock, serious personal injury, death or property damage.

Save these instructions and review frequently for conti-

nuing safe operation and instruction of future users, if ne-

cessary. Failing to follow these guidelines and if the

heater is not installed according to installation instructions

included in the box, the manufacturer could not be held

responsible for the warranty.

ATTENTION

1. Carefully read these instructions before installation.

2. Do not use heater as a towel dryer, stand or shelf.

3. Do not cover heater.

4. Disconnect power before cleaning or servicing

and replace front cover before putting power back.

ASSEMBLY OF OHY-CM OPTION

Keep a clearance of 1219 mm (48 in) minimum in front

of heater and 25 mm (1 in) to any walls.

ASSEMBLY STEPS FOR CAST TRIM SLEEVE OHY-CM

OPTION:

1. In order to proceed to the installation of this option, a

OHY unit heater must be purchased, separately. Remove

front cover by unscrewing both screws at the bottom.

2. Remove the inside module to which the fan is fixed by

loosening the four (4) RED screws.

3. Remove all 4.76 mm (3/16 in) knock-outs

(item C in the figure).

4. Insert heaterʼs enclosure within the trim sleeve as shown

and use the four (4) screws (provided in the trim sleeve

packing) to assemble both parts together. Tighten these

screws carefully with low torque to avoid stripping the

threads. Pay attention to labels indicating the orientation

of each component.

5. Fix the assembly to the wall as shown using the holes

indicated as item B in the figure. As needed use the four

(4) anchors for gypsum provided within packing. DO NOT

FIX THE HEATER WITH THE HOLES MENTIONNED IN

STEP #2 USED TO SCREW THE INSIDE MODULE;

THIS MAY CAUSE THE HEATER TO MALFUNCTION.

6. Proceed with heater installation as described in the

heaterʼs instructions provided with the latter.

WARRANTY

Ouellet Canada Inc. warrants the electric heating element of the OHY Series

for a five (5) year period and the component parts against defects in material

and workmanship for a two (2) year period following the date of purchase,

under normal use and service, when proof of purchase of such is provided to

the manufacturer. The obligation of Ouellet Canada Inc., under the terms of

this warranty, will be to supply a new unit and this omits the manufacturer to

bear the installation costs or other secondary charges linked to replacing the

unit or the component part(s).

INS111-200702-01

12" (305 mm)

Recommended

4" (102 mm)

Minimum

KOE Ø7/8”