Milestone Analytics 2.2 Generic VA - Manual (Page 8)

7
XProtect Professional system with a user account set
up through the system's Management application (in
version 7.0 or later) or Image Server Administrator (in
versions earlier than 7.0). For this purpose, the user
must have full access rights to all cameras used in
connection with the analytics solution.
If Using XProtect Corporate
If using XProtect Corporate, version 2.0b or later is required
for integration with XProtect Analytics.
If you require information about how to install XProtect
Corporate, refer to the Administrator’s Manual available on the
XProtect Corporate software DVD as well as from
www.milestonesys.com. When XProtect Corporate is installed,
do the following:
 Add the cameras you require for your analytics
solution: If you have not already added the cameras
you are going to use with your analytics solution to
your XProtect Corporate system, open the XProtect
Corporate Management Client (in some versions called
the Manager), and use the Hardware Detection Wizard
to add the cameras you require for use with video
contents analysis.
 User with full access: Technically, the analytics
solution will log in to your XProtect Corporate system
with a user account set up through the Management
Client/Manager. For this purpose, the user account in
question most have a role with full access rights to all
cameras used in connection with the analytics solution.
XProtect Transact
XProtect Transact version 2.5c or later is required for
integration with XProtect Analytics.
An add-on component used with the main surveillance system,
XProtect Transact is normally used for integrating data streams
from cash registers, ATMs, etc. with time-linked video.
XProtect Transact is, however, extremely good at handling
data streams from other sources as well, and is thus ideal for