2.7 save project settings, Save updated magellan project settings, Create new magellan package – Innotech eServer User Manual
Page 83: E 4-14, E 4-15
Page 83
eServer Setup and Site Installation Instructions
© Mass Electronics Pty Ltd 2009
Chapter 4 – Configuring eServer Communications
4-2.7 Save Project Settings
Once all project settings have been updated, ensure to use Save As to save a new revision of the
Magellan project file, as illustrated below in Figure 4-14.
Figure 4-14: Save updated Magellan project settings
Relaunch eServer. Check that it is using the updated Magellan project. Ensure to create a new
Magellan Package file for use with eServer, as illustrated below in Figure 4-15.
Figure 4-15: Create new Magellan package
Before finishing, ensure to remove the Magellan Builder security dongle, leaving just the eServer security dongle
to enable operation of the eServer software.
IMPORTANT