Innotech eServer - Manual (Page 21)

Page 21
eServer Setup and Site Installation Instructions
© Mass Electronics Pty Ltd 2009 Chapter 2 – Installation and Configuration
2-2.2.2 Port Forwarding and Firewalls
The following Ports are required to be opened through the Firewall to allow incoming and outgoing
connections to specific parts of the Innotech System.
NOTE
At a minimum ensure to enable Port 80 (Internet), Port 1433 (SQL database), Port 20000 (iComm) and Port 20001
(eServer graphics).
1 Enabling VNC, FTP or VPN assists with remote site access to the computer for management and
file transfers. This is optional but highly recommended as it allows remote diagnostics, analysis
and troubleshooting of site problems if they occur.
2 Enabling Ports 8227, 8228 and 8230 is only necessary for remote access using Chronicle Manager
to configure the site Chronicle Server.
3 The HASP security dongles used by eServer and Magellan do not fully support Remote Desktop.
You will not be able to launch eServer or Magellan through Remote Desktop.
Required Ports Usage
Port 80 Standard Internet Port
Port 20000 Innotech Communications Server (iComm)
Port 20001 Innotech eServer Graphics
Port 21000 Innotech Facility Manager (if required)
Port 1433 (TCP) SQL Server Express database
Recommended Additional Ports 1
Port 5900 For VNC (Virtual Network Computing)
Port 21 For FTP (File Transfer Protocol)
Port 1723 For VPN (Virtual Private Network)
Optional Ports Usage
Port 8227, 8228, 8230 2
Innotech Chronicle Manager remote communications with the
Chronicle Server (if required)
Port 3389 3 For Remote Desktop (mstsc)
Table 2-1: Required Ports for an Innotech System