FUTEK LSB200 S-Beam Jr - Manual (Page 3)

A D V A N C E D S E N S O R T E C H N O L O G Y , I N C .
FUTEK
ADVANCED SENSOR TECHNOLOGY, INC.
LSB200 MANUAL
INSTALLATION GUIDE
www.futek.com 10 Thomas, Irvine, CA 92618 USA · (949) 465-0900
EM1007 · 3
When handling the sensor, do not pinch the ends
where the load is applied.
When installing the sensor, connect it to an instrument
and monitor the output to prevent possible overload.
Do not apply excessive torque or create a torque
through the sensor when attaching the fixtures.
In an environment with a high amount of moisture or
humidity, create a drip loop on the cable to prevent
any water from flowing into the sensor.
For compression, install the sensor right side up for
best results (reference the label). For tension, install
the sensor upside down so the load is being applied
to the measuring end.
When routing the cable to an instrument, you want to
create a service loop in the cable so it is not taut or
stretched. (Cable bend radius of 0.80" should be
maintain where possible.)
OK