FUTEK IAC200 Junction Box - Manual (Page 5)

IAC200 Quick Start Guide 5
EM1006
b. Option 2
i. Turn on one of the channels and place a load on the corresponding load
cell.
ii. Adjust the span on the internal amplifier until the output matches the
level of the load placed on the load cell. This is adjusted as it would be
for the CSG110.
Note: If current output is desired, and the previous output voltage range
was 0-5 V, then the current setting switches will need to be changed on the
internal amplifier to DOWN, UP, DOWN on SW5, SW6, andSW7,
respectively (see Current Setting on page 7 of the CSG110 product manual
for more settings). This will achieve a 4-20 mA output. The Signal Select
DIP switches on the IAC200 will also have to be changed to output a
current signal.