Dwyer DLP - Manual (Page 2)

©Copyright 2012 Dwyer Instruments, Inc. Printed in U.S.A. 8/12 FR# R6-443670-00 Rev. 2
3. Once the snap-ring has been removed, press gently on the white
disk to force one end up for easy removal.
4. Use 9/16˝ (15 mm) wrench, or a non-slip grip, to remove the NPT
end.
5. Gently slide the circuit board from the metal case.
6. Set the circuit board down and make note of the orientation of the
battery’s positive (+) terminal. The “+” indication is also on the circuit
board.
7. Remove the old battery and install the new battery noting the
orientation of the positive (+) terminal.
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46360, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
SOFTWARE INSTALLATION
1. Insert installation CD and click Install Dwyer 2.00.
2. Follow onscreen instructions.
3. Next, click Install USB Interface Drivers on the CD Contents screen.
4. Click Install.
CONNECT THE LOGGER
1. Remove the Warning sticker from the USB Data Logger Interface
converter to uncover the female end of the jack.
2. Insert one end of the jack into the USB Data Logger Interface
converter and the other end into the serial port in the data logger.
3. The serial port is located under the cap that has the key ring hole.
Unscrew the cap and connect the cable.
4. Connect the DL700 USB cord to the PC and connect the other end
to the USB Data Logger Interface converter.
START THE LOGGER
1. To start the logger, from the Communication menu select Auto
Configure Port.
2. From the Device menu select Start Device and choose the desired
Reading Rate.
3. Click the Start button.
4. The logger will stop recording when the device is full or when Stop
Device is selected from the Device menu.
DOWNLOAD DATA
1. To download data, connect the logger to the PC.
2. Select Read Device Data from the Device menu.
3. Data is then presented graphically.
*For more detailed information on using the DL700 software, please
consult the Software Manual.
BATTERIES
Typical battery life is 1 year. Fast logging will considerably shorten the
battery life. To preserve battery life, it is recommended to use the longest
practical sampling rate, and when the logger is not in use, select Stop
Device from the Device menu.
BATTERY REPLACEMENT INSTRUCTIONS
1. Remove the end cap with the key ring hole in it, revealing the serial
port.
2. Remove the snap-ring with snap-ring pliers.
8. Repeat steps 5 through 1 in reverse order to complete installation.
MAINTENANCE
Upon final installation of the Series DLP Data Logger, no routine
maintenance is required. The Series DLP is not field serviceable and
should be returned if repair is needed (field repair should not be
attempted and may void warranty). Be sure to include a brief description
of the problem plus any relevant application notes. Contact customer
service to receive a Return Goods Authorization number before
shipping.
A message may appear stating that the software has not
passed Windows Logo Testing. This software has been tested
and works properly. Click Continue Anyway if this window appears.
NOTICE
Starting the device erases all data currently stored in the logger. NOTICE
Depending on where you purchased the battery, the leads may
not be bent correctly or at all. Follow the diagram below for
bending the battery leads properly.
NOTICE