Dwyer WTP - Manual (Page 2)

Training Output Models
• Attach desired output modules to receiver as described in output
module manual.
• Apply power to the receiver and output modules (LED on receiver
should be lit. LED on output module will flash and go out).
• Remove cover of sensor and install the batteries (observe polarity).
LED next to the transmitter training button will flash every 10 seconds.
• Press and hold the plastic service button on the output module to be
programmed. At the same time, press for one second and release the
button on the sensor. When the LED on the output module lights,
release the service button. The LED on the output module will go out
after the button is released.
• Output module LED will flash when it receives data from sensor.
• Close cover when all of the output modules have been trained.
©Copyright 2009 Dwyer Instruments, Inc. Printed in U.S.A. 12/09 FR# R6-443756-00
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
MAINTENANCE, CLEANING AND REPAIR
After final installation of the unit, no routine maintenance is required. A
periodic check of the system calibration is recommended. The Series
WTP is not field serviceable and should be returned if repair is needed
(field repair should not be attempted as it may void warranty). Be sure
to include a brief description of the problem plus any relevant application
notes. Contact customer service to receive a return goods authorization
number before shipping.
Error
Temperature or humidity
reading is incorrect
Temperature or humidity
reading is coming out of
wrong output module
Required Action(s)
• Check wire from output modules to
controller for proper connections and
polarities.
• Check to see if the controller’s software
is configured correctly.
• Check transmitter to see if its LED
flashes every 10 seconds. If not, change
batteries.
• Check power to the receiver and output
module.
• Check output module LED. If blinking
fast, retrain output module.
• Retrain output module.
DIAGNOSTICS
FIGURE 3: Battery Polarity
MOUNTING
OSA/Duct Sensors
Mount unit to surface using four #10 screws through the holes in the
mounting feet. For concrete or cinder block, pre-drill four 5/32˝ (4 mm)
holes to 1-3/4˝ (45 mm) depth. On duct models, only compress gasket
half of original thickness. Follow Orientation as shown in Figure 2.
Insertion Sensors
Thread 1/2˝ connection into 1/2˝ NPT thermowell until sensor bottoms
out against well.
FIGURE 1: Mounting Diagram
FIGURE 2: OSA Mounting Orientation
W-WTP:E-53(english) 12/23/09 8:35 AM Page 2