Crystal nVision Lab Reference User Manual

Page 2

1 Unclip the Rear Bezel from the Rear Panel Assembly of the nVision

Lab Reference.

2 Place nVision Lab Reference into Rack Panel opening (from the front as

shown in diagram) until the front bezel stops against the Rack Panel.

3 Remove the four (4) mounting screws on the Rear Panel Assembly of

the nVision Lab Reference.

4 Gently pull Rear Panel Assembly aside without disconnecting either

the interconnect cable or BARO tube from the inside components.

Note:

BARO port and connected tube will only exist on units that

have the BARO Module option.

5 Slide Flange Bracket into exposed channel of Enclosure extrusion as

shown on the drawing. Note that the Flange Bracket must face toward
Rack Panel. Position completely against the rear side of the Rack Panel
and install M4 set screws to secure.

6 After M4 screws are secure, install and tighten the set screws

into the brackets.

7 Reinstall the Rear Panel Assembly using the four (4) mounting screws

and replace the rear bezel.

8 The rack mounted nVision Lab Reference is now ready to be

installed into the Rack.

nVision
Lab Reference
Rear Bezel

Rack Mount Kit

P/N 4302

Mounting

Screws

(4 PL)

Set

Screws

(4 PL)

M4 Screws

(4 PL)

not provided

nVision
Lab Reference

Rack Panel
(19 inch shown)
not provided

Flange
Bracket

nVision
Lab Reference
Rear Panel
Assembly

708 Fiero Lane, Suite 9, San Luis Obispo, California 93401-8701

4566. C