Crystal DataLoggerXP Digital Pressure Gauge Software - Manual (Page 41)

Support  39
XP2i Operation Manual
—
softWare
LabVIeW™ drivers and Programming Instructions
Control and communicate with XP2is using National Instrument’s LabVIeW , or our Programming Instructions . Integrate XP2is into your test environment!
configXP configuration software
Use configXP to disable unwanted pressure units, set default pressure units, change water density, adjust calibration, and more via the RS-232 interface.
—
rePLaceMent Parts
The only user-replaceable parts are the batteries and the included CPF adapter fitting.
—
accessorIes
P/n 2984 ac adapter Kit
Permits operation of an XP2i from an AC supply of 90 - 264 VAC and 47 - 63 Hz . Includes interchangeable international plugs (for USA, Europe, U .K ., and Australia) .
Adapter will not charge batteries, but in the event of AC power loss, XP2is will automatically revert to battery operation .
!
WaRninG: do not use the ac adapter Kit in hazardous locations.
P/n 3009 Plastic carrying case
35 .6 cm (14”)L x 27 .9 cm (11”)W x 8 .3 cm (3¼”)H with egg-shell foam interior .
P/n 3696 Protective Boot
Skydrol™ resistant protective boot .
!
WaRninG: do not use the Plastic carrying case or Protective Boot in hazardous locations.
P/n 2955 6” gauge adapter Kit
Adapts the 4½” Panel Mount (F4 option) to fit into a 6” gauge cutout .
P/n 2956 8½”gauge adapter Kit
Adapts the 4½” Panel Mount (F4 option) to fit into an 8½” gauge cutout .
P/n 3313 usB-rs232 adapter
USB B receptacle to RS232 DB9M .
!
WaRninG: do not use the usB-rs232 adapter in hazardous locations.
P/n 2400 rs232 cable
DB-9 male to DB-9 female straight pass-through cable .
!
WaRninG: do not use the rs232 cable in hazardous locations.