Crystal DataLoggerXP Digital Pressure Gauge Software - Manual (Page 31)

Safety & Certifications  29
XP2i Operation Manual
Safety & Certifications
—
haZardous LocatIons
Every XP2i pressure gauge includes the following Intrinsic Safety approvals:
II 1g ex ia IIc t4/t3 ga
ftZu 12 ateX 0048 X
This product conforms to the following standards:
EN 60079-0 :
2009 | EN 60079-11: 2012 | EN 60079-26: 2007
ex ia IIc t4/t3 ga
Iecex ftZu 12.0009 X
This product conforms to the following standards:
IEC 60079-0 : 2011 | IEC 60079-11: 2011-06 | IEC 60079-26: 2006
!
WaRninGS: the following warnings apply to the XP2i:
•
use of duracell Mn1500 batteries is not approved for csa certification.
•
do not use the rs-232 connector in hazardous locations.
•
replace batteries in non-hazardous locations and with approved types only.
•
do not mix battery types or manufacturers.
•
t4, t3c, or t3 temperature class is based on selection of approved battery. see approved Batteries table on page 27.
•
Special conditions for safe use:
•
the equipment shall not be installed in a location where external conditions are conducive to the buildup of electrostatic charge.
•
Because the enclosure of the XP2i and XP2i-dd is made of aluminium, if it is mounted in an area where the use of category 1 g apparatus
is required, it must be installed such that, even in the event of rare incidents, ignition sources due to impact and friction sparks are excluded.
—
certIfIcatIons
The XP2i has been tested and certified to comply with a variety of international standards.
This XP2i complies with the Australian requirements for the C-tick mark.
The instrument was tested against AS/NZS 3548, C-tick EMC/EMI requirements.
Crystal Engineering declares that the XP2i is in accordance with the ATEX Directive, the Electromagnetic Compatibility Directive, and the Pressure
Equipment Directive per our declaration(s).
This XP2i is approved for use as a portable test instrument for Marine use and complies with Det Norsjke Veritas’ Rules for Classification of Ships, High
Speed & Light Craft, and Offshore Standards.
ATEX
C-tick
Intrinsically Safe and Non-incendive for Hazardous Locations: Class I, Division 1,
Groups A, B, C and D, Temperature Code T4 or T3C.
CSA