Thermo Fisher Scientific Precision pH/mV Simulator - Manual (Page 7)

Instruction Manual pH Simulator
4
3 Preparation
3.1 Inserting & Removing Rubber Boot
1. To remove simulator from rubber boot, push out from the bottom edges of
simulator until it is completely out of boot. Ensure that the BNC cables are not
connected.
2. To insert simulator into rubber boot, slide in from the top of meter before
pushing the bottom edges of simulator down to set it into position. Lift up the
stand at the back of simulator for bench top applications if necessary.
Figure 3: Inserting or removing the rubber boot