Thermo Fisher Scientific Alpha COND 560 - Manual (Page 33)

27
5.7 Configuration Settings
Configuration settings let you to enable/disable backlight of the LCD, select
between 2-cell & 4-cell and reset the controller to factory defaults.
ENT
SETUP
HOLD
2
SETUP
HOLD
2
ENT
ENT
SETUP
HOLD
3
SETUP
HOLD
3
ENT
SETUP
HOLD
SETUP
HOLD
5
4
ENT
ENT
SETUP
HOLD
ENT
ENT
SETUP
HOLD
5
SETUP
HOLD
5
ENT
1
MEAS
°C
ATC
READY µS
This screen appears only
when 2-cell is selected
and measuring range is set to
0.0 to 200.0 mS/cm
R.
1 1 From measurement mode press ENT key to enter setup mode as
described in section 5.1. The LCD shows the first screen of setup mode
(rAng). Press
▲ or ▼ key to select configuration settings screen
(Cnfg).
Press ENT key to access configuration settings (Cnfg).
2 Enable/disable LCD backlight: The upper display shows ‘LitE’. The
lower display shows last configured backlight selection (‘On’ or ‘OFF’).
Press ▲ or ▼ key to enable (LitE On) or disable (LitE OFF) backlight