Revo REJCPTZ-2 - Manual (Page 13)

Part IV Control of PTZ Camera
■ Connection between keyboard and PTZ camera
■ Control PTZ camera through keyboard
■ PTZ Camera control command index
RS485 Connection between keyboard and PTZ camera
Ensure the keyboard’s control Protocol and Baud rate (Default: REVOTRAX
protocol and 9600 Baud rate) matches the connected PTZ camera(s).
If different protocols or baud rates are needed, change them in the keyboard menu
set up. (See Section III – Keyboard Setup).
Ensure that all RS485 connections are correct – One wire should be connected to
all “A” (or “+”) contacts, and the other wire should be connected to all “B” (or “-“)
contacts. It’s not necessary to use the “G” (ground) terminal on the RS-485 connector
when connecting the keyboard to the other devices.
Part III
Keyboard Setup
■Setting Key
■Setting Procedure
■Menu Index
Joystick calibration, Protocol, Baud Rate, Camera ID and other functions can be set up
in the “Keyboard Set” mode.
Setting Keys: (Keys will be used)
【CANCEL】 Delete key/Exit key
【ENTER】 Confirmation key
【F1】 Special function key
【SHIFT】 Assistant function key
How to Set up
While holding the【SHIFT】+【F1】keys down at the same time, apply power to the
keyboard. The protocol and Baud rate will be displayed for a few seconds. Continue
holding the keys down, and the keyboard will enter the “Keyboard Set” mode.
Release the SHIFT and F1 keys and press “Enter” to change the keyboard’s settings.
Press【F1】to go to the next menu option (1, 2, 3, etc.). Press【CANCEL】to exit the
set-up menu. Press【ENTER】to change the setting or confirm setting information.
Keyboard set
Enter to menu
8 11