Revo REJCPTZ-2 - Manual (Page 12)

Back Port Function Introduction:
RS485 Port: Connect to the communication port(s) of other devices
(i.e. PTZ cameras).
Power Port: (12V @1000mA)
Green LED (on COM port): No user function.
Yellow LED (on COM port): Flickers when joystick is operated.
Power On:
Use the included DC12V 1000mA wall adapter to supply power to the keyboard.
Power on：
1. The keyboard will beep to indicate that it has powered up successfully.
2. The LCD screen will briefly display the communication protocol and baud
rate:
Keyboard hints:
Audible Annunciator:
The keyboard will beep one time to indicate each key press.
The keyboard will quickly beep multiple times to indicate an incorrect
operation.
Control PTZ Camera through Keyboard
Functional Keys Introduction:
【MENU】Brings up the camera’s menu when pressed
【MENU】: Camera’s menu is displayed on the video monitor
【#】+【MENU】: No function
【SHIFT】+【MENU】: Pattern Setup is displayed
【#】+【SHIFT】+【MENU】: Pattern # is started
【ESC】Normally escapes without saving changes when in camera menu mode
【ESC】: Exit and without saving changes
【#】+【ESC】: Auto scan setup # is displayed.(For # 1,2,3,4,5. 5 brings up auto
scan 9)
【SHIFT】+【ESC】: No function
【#】+【SHIFT】+【ESC】: No function
【 CTRL】 Activates the CTRL function(Either toggles or holds, depending on
function)
In PTZ control mode, holding the CTRL key increases the speed of the PTZ’s
movement
【TOUR】Brings up the Tour setup menu (If 0+Tour)
【TOUR】: The camera’s Tour setup is displayed.
【#】+【TOUR】: Tour # is started.
【SHIFT】+【TOUR】: Home function
【#】+【SHIFT】+【TOUR】: # Tour setup is displayed
【PRESET】Call or Set preset position and setup preset menu
【PRESET】: The preset setup menu is displayed
REVOTRAX
9600
Protocol
Baud rate
7 12