Precision Control Systems ChamberIR 4069 - Manual (Page 5)

1-1
Section 1 – INTRODUCTION
The Model 4069 ChambIR
®
infrared chamber heater is designed for use in any
application that requires a high-intensity, clean, responsive, non-contact heat source.
This heater can be used for both continuous processes and test specimens.
Typical applications for the Model 4069 include:
Curing silicone tubing
Re-glossing rubber and plastic tubing
Skin cure automotive hoses and tubing
Burning lubricant off of extruded wire
Preheating metal parts prior to rubber or plastic coating
Curing coatings or adhesives on wire or cable
The Model 4069 includes the following major components:
Heater Module – The heater has highly polished aluminum reflectors that direct the
infrared energy generated by ceramic end-seal ‘T-3 style’ quartz halogen lamps, which
are factory-installed in the heater. Heated lengths of 10, 16, 25, and 38 inches (254, 406,
635, and 965 mm) are offered for the Model 4069. Additional lamps can be ordered
separately from the heater.