Martel Electronics MC1200 - Manual (Page 48)

9. Maintenance / Warranty
9.1 Replacing Batteries
Replace batteries as soon as the battery indicator turns on to avoid false measurements. If
the batteries discharge too deeply the MC1200 will automatically shut down to avoid battery
leakage.
Note: Use only AA size alkaline batteries or optional rechargeable battery pack.
9.2 Cleaning the Unit
Warning
To avoid personal injury or damage to the calibrator, use only the specified replacement parts
and do not allow water into the case.
Caution
To avoid damaging the plastic lens and case, do not use solvents or abrasive cleansers.
Clean the calibrator with a soft cloth dampened with water or water and mild soap.
9.3 Service Center Calibration or Repair
Only qualified service personnel should perform calibration, repairs, or servicing not covered
in this manual. If the calibrator fails, check the batteries first, and replace them if needed.
Verify that the calibrator is being operated as explained in this manual. If the calibrator is
faulty, send a description of the failure with the calibrator. Be sure to pack the calibrator
securely, using the original shipping container if it is available.
9.4 Replacement Parts & Accessories
700MA Fluke Module Adapter
BPPA-100 BETA Pressure Module Adapter
80029 JKTE T/C Wire Kit, Mini Plugs
80036 RSNB T/C Wire Kit, Mini Plugs
CC572 Carrying Case
C232SJ RS232 Cable with Miniature Plug
5353050 48" Stackable Testleads
1001-9V Battery Adapter/Charger
9.5 Warranty
Martel Electronics Corporation warrants all products against material defects and
workmanship for a period of twelve (12) months after the date of shipment. Problems or
defects that arise from misuse or abuse of the instrument are not covered. If any product is to
be returned, a “Return Material Authorization” number must be obtained from our Customer
Service Department. This number must be indicated on the return package as notice to our
Receiving Department to accept the shipment. Any package not so marked will not be
accepted and will be returned to the shipper. Martel will not be responsible for damage as a
result of poor return packaging. Out of warranty repairs and recalibration will be subject to
specific charges. Under no circumstances will Martel Electronics be liable for any device or
circumstance beyond the value of the product.
48