Martel Electronics TC100 - Manual (Page 8)

6
Before beginning, become familiar with the key-
pad layout and the configuration of the
input/output jacks. See Figure 1.
In the basic or “as shipped” setup, the TC100
allows the user to step through all available T/C
types (10 plus mV). In certain situations this
may be confusing to infrequent users as to
which type to use.
The optional advanced setup mode allows a
supervisor through password control to “blank
out” or disable unwanted T/C types so that only
the proper T/C types can be selected. The fol-
lowing procedure outlines how this is done:
1. Hold down the TC TYPE key at power up.
2. The word PASS will be displayed and you
need to introduce the password 123 as
follows:
Rotate the knob to 1, press SET key, rotate
to 2, press SET, rotate to 3, press SET.
3. You can toggle through all the thermocouple
types by pressing TC TYPE key.
4. Press SET key for the ones that you want to
keep.
5. The last TC type is mV. By pressing TC
TYPE key again, you’ll exit from this mode
and return to normal operation.
6. If you missed one, repeat the entire proce-
dure again.
4. Operating Procedure
1. Turn on power and select the desired thermo-
couple type by depressing the T/C Select key.
Once the desired T/C is selected, it will remain
in memory until a new T/C type is selected.