Martel Electronics TC100 - Manual (Page 11)

9
7. Setpoint Feature
The TC100 allows the user to program up to 3
setpoints for each TC type (including mV). to
set the setpoints complete the following proce-
dure:
1) Turn on the TC100 and select the Source
Mode.
2) Select the TC type to be simulated and cor-
rect units (either °C or °F).
3) Press to see what is currently
stored in each of the 3 setpoints.
4) To store a new value adjust the output to the
desired value then press the key.
5) Repeat steps 3 & 4 until all 3 setpoints are
stored.
6) Once the setpoints are stored, press the
key to recall the newly stored set-
points.
7) Each press of the key will incre-
ment to the next stored setpoint.
Note: Setpoints are non-volatile and will
remain in memory until changed.
8. Min/Max Datalogging
When the TC100 is in the measure mode it will
continuously monitor and store the minimum
and maximum values for that particular input.
To operate the datalogging feature use the fol-
lowing procedure:
Recall
Recall
Set
Recall