Martel Electronics DPC300A - Manual (Page 32)

30
6.5 Remote Commands and Error Codes
The following tables list all commands, and their descriptions, that
are accepted by the calibrator.
Table 5: Common Commands
Command Description
*CLS (Clear status.) Clears the error queue.
*IDN? Identification query. Returns the manufacturer, model num-
ber, and firmware revision level of the Calibrator.
*RST Resets the calibrator to the power up state.
Table 6: Calibrator Commands
Command Description
DAMP Turns Damp on or off.
DAMP? Returns if DAMP is on/off
DISPLAY Turns on/off the displays specified in the command
DISPLAY? Returns which displays are on/off
ERROR_LOOP Turns loop power on or off in percent error mode
ERROR_LOOP? Returns the current state of loop power in error mode
ERROR_MODE Turns percent error mode on or off
ERROR_MODE? Returns whether percent error mode is on or off
ERROR_PORT
Set the pressure port for percent error mode
ERROR_PORT? Returns the pressure port for percent error mode
FAULT? Returns the most recent error code
FUNC Sets the display mode as specified in the command
FUNC? Returns the current mode of the upper, middle, and lower
display
HART_ON Turns the hart resistor on.
HART_OFF Turns the hart resistor off.
HART? Returns the current state of the Hart resistor.
HI_ERR Sets the 100% of span limit for percent error mode
HI_ERR? Returns the 100% of span limit for percent error mode
IO_STATE Set the calibrator's mA state.
IO_STATE? Return the calibrator's mA state.
LOCAL Returns user to manual operation of the calibrator
30