Changing brake shoes, Bleeding and filling brake, Changing.brake.shoes bleeding.and.filling.brake – MAGURA HS33 (2014) User Manual
Page 21: Ones.– see, Leeding, Filling, Brake
21
E
N
g
LI
S
H
C
hanging
Brake
shOes
Danger of accident due to brake failure caused by faulty installation.
Î
–
Use.only.original.MAGURA.brake.shoes.appropriate.for.your.rim.type.
L
L
There.are.4.different.original.MAGURA.brake.shoe.blends:.
Black.–.Standard.for.uncoated.aluminium.rims.
Red.–.High-grip.blend.for.uncoated.aluminium.rims.
Grey.–.Standard.for.anodised./coated.aluminium.rims.
Green.–.High-grip.for.anodised./coated.aluminium.rims
.
)
Screw.the.adjusting.screw.(TPA).
.on.the.corresponding.brake.lever.
out.as.far.as.the.stop.
(
-
.
.
)
Open.the.brake.– see.
.
)
Remove.the.wheel.
.
)
Pull.off.worn.brake.shoes.
.
)
Clean.the.brake.shoe.holders.
.
)
Push.on.new.brake.shoes.–.allow.them.to.engage.
.
)
Install.the.wheel.
.
)
Apply.the.brake.– see.
Danger of accident caused by brake failure.
Î
–
Pull.and.hold.the.brake.lever.and.check:.
that.no.oil.is.leaking.from.any.part.of.the.brake.system..
Brake.pads.are.in.full.contact.with.the.brake.track.area.
Pressure.point.is.clearly.noticeable.and.does.not.change.
Danger of accident by bursting tires.
Î
–
Make.sure.that.the.brake.pads.cannot.contact.the.tires.
.
)
Set.the.pressure.point.– see.
B
leeDing
anD
filling
Brake
L
L
EBT.(Easy.Bleed.Technology).makes.it.easy.to.bleed.the.brake.
L
L
The.only.difference.between.bleeding.and.filling.–.if.any.–.is.the.amount.
of.oil.required.–.the.procedure.is.identical.
L
L
Always.fill.at.the.brake.cylinder,.never.at.the.brake.lever!
Loss of oil and irreparable damage to the braking system.
Î
–
Open.the.screw.plugs.for.bleeding.and.filling.only.
Î
–
Use.MAGURA.Royal Blood.(mineral.oil).exclusively.for.bleeding.and.
filling.–.never.DOT.brake.fluid.
L
L
Because.MAGURA.Royal Blood.does.not.age,.it.is.not.necessary.to.
bleed.or.refill.your.MAGURA.brake.regularly..Do.this.only.if.one.of.the.
following.reasons.requires.it:
О
О
The.brake.does.not.respond.immediately.when.the.brake.lever.is.actu-
ated.
О
О
Pressure.point.is.not.clearly.defined,.it.is.spongy.or.does.not.remain.
constant.
О
О
After.changing.the.brake.hose.
L
L
To.bleed.or.fill.your.MAGURA.brake.you.will.need.the.MAGURA.Service
Kit.or.the.MAGURA.Pro Bleed Kit.–.available.from.dealers.
.
)
Insert.barbed.fitting.
.tightly.into.the.filling.line.by.hand.
.
.
)
Fill.filling.syringe.
.with.MAGURA.Royal Blood.
.
)
Make.sure.that.there.is.no.air.in.the.filling.syringe.and.filling.line.
.
)
Remove.the.piston.of.the.bleeding.syringe.
.
.
)
Make.sure.that.the.pressure.point.adjusting.screws.(TPA).
.are.
.unscrewed.to.the.stop.(-).