Alliance Laundry Systems CHM1766C - Manual (Page 10)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232224 8
Programming Cycle Segments
The machine has 30 wash cycles available. 26 wash
cycles are pre-programmed. 4 cycles are available for
custom programming. All wash cycles may be edited
as follows.
1. Enter PROGRAM Mode. Refer to Entering
Program Mode section.
2. Press “ ∧” keypad to enter PROGRAM Mode.
3. Press the cycle number of the cycle to be edited.
Refer to Table 1.
4. Press the START keypad to move into the menu
of options. Refer to Figure 1.
NOTE: While cycle is running, pressing the START
keypad shows the temperature. Pressing the
START keypad a second time displays the cycle.
Pressing the START keypad a third time returns
display to time remaining.
Figure 1
CHM1766C
1 Cycle Keypad “1” 11 Door Open LED
2 Cycle Keypad “3” 12 Spin Cycle LED
3 Cycle Keypad “5” 13 Rinse Cycle LED
4 Rapid Advance/Up “ ∧ ” Edit 14 Add Bleach LED
5 Cycle Keypad “2” 15 Wash Cycle LED
6 Cycle Keypad “4” 16 Out-of-Balance Indicator Dot
7 Cycle Keypad “6” (Variable-speed only)
8 Stop/Down “ ∨ ” Edit 17 High Water Level Indicator Dot
9 START Keypad 18 Medium Water Level Indicator Dot
10 CLEAN FILTER Indicator LED 19 Low Water Level Indicator Dot
CHM1766C
< <
1 2
3 4
5 6
1
5
6
7
8
10
2
16 17 18 19
11
12
13
14
15
4
9
3