KROHNE BATCHFLUX 5500 C EN - Manual (Page 16)

4
ELECTRICAL CONNECTIONS
16
BATCHFLUX 5500 C
www.krohne.com 05/2014 - 4000827703 - HB BATCHFLUX 5500 R03 en
4.1 Safety instructions
4.2 Grounding
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
DANGER!
Observe the national regulations for electrical installations!
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
CAUTION!
The grounding wire should not transmit any interference voltage. Therefore do not ground any
other electrical device at the same conductor.
CAUTION!
When connecting to functional extra-low voltages (24VDC) , ensure that you use protective
separation (PELV) according to IEC 364/IEC 536 or VDE 0100/VDE 0106.