KROHNE SMARTSENS PH 8530 EN - Manual (Page 16)

3
INSTALLATION
16
SMARTSENS PH 8530
www.krohne.com 11/2013 - 4002544802 - MA SMARTSENS PH 8530 R02 en
3.6 Installing the sensor
3.6.1 General installation instructions
The membrane glass must always have full contact with the measuring medium.
The mounting position of the sensor should not deviate more than 75° from vertical position
(sensor tip pointing downwards). Doing otherwise might cause internal air bubbles to float into
the membrane glass. This would interrupt the electrical contact between the inner buffer
solution and the glass surface.
Figure 3-6: Installation requirements
1 Measuring medium
2 Maximum deviation of 75° from vertical position
.book Page 16 Monday, November 18, 2013 4:32 PM