KROHNE OPTITEMP TC 100 Ex EN - Manual (Page 9)

INSTALLATION
3
9
OPTITEMP TR/TC100
www.krohne.com 08/2010 - 4001022701 - Ex AD OPTITEMP TR/TC 100 R01
Installation
3.1 Special Conditions
Operate the measuring insert only if it is installed in a connection head.
3.2 Installation
Installation and setup must be carried out according to the applicable installation standards (e.g.
EN 60079-14) by qualified personnel trained in explosion protection. Observe the information
contained in the manuals and the supplementary instructions.
Install the measuring inserts such that
• the terminal base is protected by a connection head,
• no external forces are acting on the measuring insert,
• the device is accessible for any necessary visual inspections and can be viewed from all sides.
DANGER!
The manufacturer is not liable for any damage or injuries resulting from improper use or use
other than the intended purpose. This applies in particular to hazards due to insufficient
corrosion resistance and suitability of the materials in contact with product.
.book Page 9 Wednesday, August 11, 2010 11:40 AM