KROHNE OPTITEMP TC 100 Ex EN - Manual (Page 3)

SAFETY INSTRUCTIONS
1
3
OPTITEMP TR/TC100
www.krohne.com 08/2010 - 4001022701 - Ex AD OPTITEMP TR/TC 100 R01
Safety instructions
1.1 General notes
These additional Ex instructions apply to explosion-protected versions of measuring inserts with
the marking II 1 G. They complement the standard documentation for non-explosion protected
versions.
The information given in these Instructions contains only the data relevant to Category 1
explosion protection. The technical details given in the standard documentation for the non-
explosion protected versions apply unchanged unless excluded or superseded by these
Instructions.
1.2 EC conformity
The manufacturer declares with the EC Declaration of Conformity on his own responsibility
conformity with the protection goals of Directive 94/9/EC for use in hazardous areas with gas.
The EC Type Test Certificate of the National Metrology Institute (PTB) forms the basis of the EC
Declaration of Conformity:
The "X" after the certificate number refers to special conditions for safe use of the device as
described in these Instructions.
You may download the EC Type Test Certificate from the manufacturer's website as needed.
1.3 Safety instructions
Assembly, installation, start-up and maintenance may only be performed by personnel trained in
explosion protection!
PTB 10 ATEX 2010 X PTB 10 ATEX 2010 X PTB 10 ATEX 2010 X PTB 10 ATEX 2010 X
CAUTION!
Should operating conditions and locations require the observance of further standards,
guidelines and laws, this is the responsibility of the operator and/or those commissioned by him.
.book Page 3 Wednesday, August 11, 2010 11:40 AM