KROHNE OPTIMASS Sensors Concentration Measurement EN - Manual (Page 4)

2
CONCENTRATION SET UP
4
OPTIMASS
www.krohne.com 01/2014 - 4000733002 - AD OPTIMASS Concentration R04
Concentration set up
2.1 Introduction
Concentration measurement on the MFC 300 and MFC 400 is an optional extra that can be
specified when ordering the meter, or purchased after delivery. If the option has been specified
at the time of ordering the meter, it will be turned on during manufacture. If it is purchsed after
delivery, a password is sent to the customer to allow the option to be turned on. When the option
has been turned on, a range of concentration menus are available through C2.
Concentration status Concentration status Concentration status Concentration status
The concentration status can be checked by entering the programme menu and C2.1. If "Conc
Password" is displayed the concentration measurement is not enabled. If you want to purchase
the concentration option, please contact your nearest representative.
2.2 Turning on concentration measurement
When you receive the concentration password, use the following sequence to turn on the option
Password sequence
2.2.1 Seven digit passwords
The password supplied will normally be eight digits. If you have been supplied with a seven digit
password, leave the first digit on the display at "0". For example, if the password you have been
sent is 1234567, enter 01234567.
2.3 Concentration menu
When the concentration has been turned on, the Concentration menu is available to the user who
can select from the available concentration modes through C2. The following table shows the
available options.
Button Screen Description and setting
> A Quick Setup Press and hold for 2.5 s, then
release key
2 x C Setup Press down arrow twice
> C1 Setup Press right arrow to enter Setup
1 x C2 Concentration
> C2 Concentration
> C2.1 Concentration Display shows Conc. Password
> C2.1.1 Conc. Password Display shows a row of zeros with
the first zero hilghted
/ / > C2.1.1 Conc. Password Use and to change the value
of each digit. Use the > key to
move to the next digit and repeat
above operation until the correct
password has been entered.
^ C2.1.2 Conc. Password Concentration On
3 x ^ C Setup Save Configuration?
^ Yes? Save changes and activate
concentration measurement
AD_Concentration_en_140124_4000733002_R04.book Page 4 Tuesday, January 28, 2014 9:28 AM