KEPCO KIT 219-0530, BOP Firmware Upgrade (10 Units) - Manual

©2007, KEPCO, INC 1
Data subject to change without notice 228-1636 REV 1
I N S T R U C T I O N M A N U A L
BOP 1000W
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11355 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
RETROFIT
KIT 219-0530
BOP 1000W
FIRMWARE RETROFIT KIT
1. DESCRIPTION
Kepco KIT 219-0530 contains ten identical PROMs used to upgrade the firmware for the GPIB interface of ten BOP
1000W power supplies. The upgraded GPIB interface firmware is more reliable in multiple unit operation, stream-
lines operation, adds recording of errors and provides for recovery of all errors reported by the GPIB.
This KIT applies only to
• Models BOP 50-20MG, BOP 72-14MG and BOP 100-10MG, all revisions
• Models BOP 10-75-MG, BOP 20-50MG and BOP 36-28MG, revision 5 and higher
• Models BOP 10-75-MG-26566, BOP 20-50MG-26828 and BOP 36-28MG-26567
NOTE: The 10V, 20V and 36V models below revision 5 which are NOT marked with 26566, 26828, 26567,
respectively, must first be upgraded using KIT 219-0491 which must be ordered separately.
When the upgrade is complete, a five digit number is added to the Model number of the modified unit to identify the
upgrade(s) installed.
2. INSTALLATION INSTRUCTIONS
2.1 MATERIAL REQUIRED (SEE TABLE 1.)
TABLE 1. MATERIAL REQUIRED
MATERIAL LOCATION QUANTITY
• PROM (Kepco P/N 250-0691) Replaces U2 in Digital Board A1 Provided in this Kit 10
• Instruction Manual 228-1636 Provided in this Kit 1
• ESD (Electrostatic Discharge) wrist strap (Kepco P/N 114-0080) Provided in this Kit 1
• IC Extractor Provided in this Kit 1