KEPCO DIN KIT RKW-150 (L) - Manual

©2003, KEPCO, INC 1
Data subject to change without notice 228-1456
I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11352 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
An ISO 9001 Company.
DIN RKW
-150L DIN-RAIL MOUNTING KIT
FOR SERIES RKW 150W
FIGURE 1. L SUFFIX ORIENTATION
INSTALL COVER. Attach the cover to the power supply per instruction manual supplied with the cover.
INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-
ure 3). The clips may be mounted with the release lever on either side to facilitate removal.
INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clamps
under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are
close together, it may be necessary to apply leverage with two screwdrivers simultaneously.
FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
TABLE 1. COMPONENTS SUPPLIED
KIT
MODEL NO.
COVER
PART NO.
MOUNTING PLATE
PART NO.
CLIP (QTY 2)
PART NO.
SCREW (QTY 4)
PART NO.
WASHER (QTY 4)
PART NO.
DIN RKW-150L CA 36 128-1938 108-0362
501-0075
(M4 X 8 FLPH)
103-0017
(NO. 8, INT. TOOTH)
A — INSTALLATION B — REMOVAL
DESCRIPTION. Kepco KIT, Model DIN RKW-150L con-
tains two preassembled mounting clips and associated
hardware used to install RKW 150 Watt Series power
supplies on a DIN rail. The -150 suffix is for the 150 Watt
Series. The “L” suffix is for mounting along the long
dimension (length) as shown in Figure 1. Outline dimen-
sions are shown in Figure 4