KEPCO DIN KIT RAX-100 (L) - Manual

©1998, KEPCO, INC 1
Data subject to change without notice 228-1302
I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
DIN RAX
-100L
DIN-RAIL MOUNTING KIT
FOR SERIES RAX 100W
DESCRIPTION. Kepco KIT, Models DIN RAX-100L, contains two preassembled mounting clips and associated hard-
ware used to install RAX 100 Watt Series power supplies on a DIN rail. The “L” suffix is for mounting along the long
dimension (length) as shown in Figure 1. Outline dimensions are shown in Figure 4.
FIGURE 1. L SUFFIX ORIENTATION
INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-
ure 3). The clips may be mounted with the release lever on either side to facilitate removal.
INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clamps
under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are
close together, it may be necessary to apply leverage with two screwdrivers simultaneously.
FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
A — INSTALLATION B — REMOVAL