KEPCO DIN KIT KRW (L) User Manual
Kepco, Din krw-l din-rail mounting kit for series krw-l

©1999, KEPCO, INC
1
Data subject to change without notice
228-1374
I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
DIN KRW-L
DIN-RAIL MOUNTING KIT
FOR SERIES KRW-L
FIGURE 1. L SUFFIX ORIENTATION
INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of the clip under
one edge of the rail, then snap the other end of the clip into place (see Figure 2A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage the clip from the rail.
FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
TABLE 1. COMPONENTS SUPPLIED
COVER
PART
NO.
CABLE KIT
PART NO.
SCREW
(QTY 8)
(Power Supply and Clips
To Mounting Frame)
PART NO.
WASHER (QTY 8)
(Power Supply and
Clips To Mounting
Frame)
PART NO.
CLIP
(QTY 2)
PART
NO.
CLIP
PLATE
(QTY 2)
PART NO.
SCREW
(QTY 2)
(Cover To Mounting Frame)
PART NO.
CA 29
219-0242
501-0017
(M3 X 6, PHPH)
103-0014
(NO. 4, INT. TOOTH)
108-0366
128-1996
101-0443
(4-40 X 1/4 BHPH)
A -
INSTALLATION
B -
REMOVAL
DESCRIPTION. Kepco Kit, Model DIN KRW-L, contains a preassembled mount-
ing frame, a cover, a cable kit and associated hardware (see Table 1) used to
install KRW Series power supplies on a DIN rail. The “L” suffix is for mounting
along the long dimension (length) as shown in Figure 1. Outline dimensions are
shown in Figure 4.
INSTALLING KIT. Install the power supply in the preassembled mounting frame
using the hardware supplied (see Figure 3). Then engage the tabs (A) of the
cover in the corresponding slots and slide the cover as shown in Figure 3 until the
power supply mounting holes (B) are aligned with corresponding holes in the
cover. Secure the cover to the mounting frame using the hardware supplied.
Attach wires to the power supply per Instruction Sheet supplied with cable kit.