KEPCO DIN KIT FAW-150 (S) User Manual
Kepco
©1998, KEPCO, INC
1
Data subject to change without notice
228-1342
I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
DIN FAW
-100S, 150S
DIN-RAIL MOUNTING KIT
FOR SERIES FAW 100W, 150W
FIGURE 1. S SUFFIX ORIENTATION
INSTALL COVER. Attach the cover to the power supply per instruction manual supplied with the cover.
INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-
ure 3). The clips may be mounted with the release lever on either side to facilitate removal.
INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clamps
under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to
apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are
close together, it may be necessary to apply leverage with two screwdrivers simultaneously.
FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
TABLE 1. COMPONENTS SUPPLIED
KIT
MODEL NO.
COVER
PART NO.
MOUNTING PLATE
PART NO.
CLIP (QTY 2)
PART NO.
SCREW (QTY 4)
PART NO.
WASHER (QTY 4)
PART NO.
DIN FAW-100S
CA 27
128-1980
108-0362
101-0092
(4-40 X 0.312 BHPH)
103-0014
(NO. 4, INT. TOOTH)
DIN FAW-150S
CA 28
128-1980
108-0362
101-0092
(4-40 X 0.312 BHPH)
103-0014
(NO. 4, INT. TOOTH)
A —
INSTALLATION
B —
REMOVAL
DESCRIPTION. Kepco KITs, Models DIN FAW-100S
and -150S, each contain two preassembled mounting
clips and associated hardware used to install FAW 100
and 150 Watt Series power supplies on a DIN rail. The
-100 suffix is for the 100 Watt Series, and -150 for the
150 Watt Series. The “S” suffix is for mounting along the
short dimension (width) as shown in Figure 1. Outline
dimensions are shown in Figure 4