KEPCO DIN KIT ERX-60 (P) - Manual

I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
DIN ERX
-60P
©2001, KEPCO, INC 1
Data subject to change without notice 228-1419
DIN-RAIL MOUNTING KIT
FOR SERIES ERX 60W
FIGURE 1. P SUFFIX ORIENTATION
FIGURE 2. INSTALLING MOUNTING BRACKET ON POWER SUPPLY
4. INSTALL CABLE KIT. Attach wires to the
power supply per Instruction Sheet supplied with cable kit.
5. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both mounting
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 4A)
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screwdriver
into the access holes provided and apply leverage towards the left as shown in Figure 4B to disengage each clip from
the rail. Where mounting clips are close together, it may be necessary to apply leverage with two screwdrivers simulta-
neously.
TABLE 1. COMPONENTS SUPPLIED
KIT
MODEL NO.
COVER
PART
NO.
CABLE
KIT
MOUNTING
BRACKET
PART NO.
SCREW
(QTY 6)
(Power Supply
To Mounting
Bracket)
PART NO.
WASHER
(QTY 6)
(Power Supply
To Mounting
Bracket)
PART NO.
CLIP
(QTY 2)
PART
NO.
CLIP
PLATE
(QTY 2)
PART NO.
SCREW
Thread-form
(QTY 4)
(Clip To
Mounting
Bracket)
PART NO.
WASHER
(QTY 4)
(Clip To
Mounting
Bracket)
PART NO.
DIN ERX-60P CA 16 219-0145 128-2055
101-0383
(8-32 X 3/16
PHPH)
103-0017
(NO. 8, INT.
TOOTH)
108-0362 128-1938
101-0443
(4-40 X 1/4
ST. TR.)
103-0014
(NO. 4, INT.
TOOTH)
DESCRIPTION. Kepco KIT, Model DIN ERX-60P
contains a cover, cable kit, left and right mounting
clips, and associated hardware (see Table 1) used
to install ERX Series 60W power supplies on a DIN
rail. The “P” suffix is for mounting the power supply
perpendicular to the DIN rail as shown in Figure 1.
Outline Dimensions are shown in Figure 5.
INSTALLATION
1. INSTALL COVER. Attach the cover to the
power supply per instruction manual supplied
with the cover.
2. INSTALL MOUNTING BRACKET. Attach the
mounting bracket to the power supply using
the hardware supplied (see Figure 2).
3. INSTALL CLIPS. Attach preassembled
mounting clips into the mounting bracket
holes using hardware supplied (see Figure 3)