AT&T System 25 - Manual (Page 32)

Inspect ✓
❑
The inspect mode allows you to use your console display to get
the following information:
■ The extension number and associated name for either a call
on hold or a call ringing at a
LOOP
button.
■ The number of trunks available in a group of trunks
represented by a
FACILITY
button.
■ The number or code stored on a
REP DIAL
,
LAST # DIALED
,
or
FLEX DSS
button.
■ The name of the feature assigned to any other button.
NOTE: In the Inspect mode, your console is unavailable to new
incoming calls. You also will
handling procedures (such as not be able to perform call-
hold, transfer, answering a call,
etc.).
Using Inspect
1 Press
INSPECT
.
2 Press the button you want to inspect.
Deactivating Inspect
When you do any of the following, you automatically deactivate
the Inspect feature:
1 Press
INSPECT
again;
2 Hang up the handset after being off-hook, lift the handset
after-being on-hook, or press an idle
LOOP
button ;
or
3 Allow the display to be idle for 15 seconds.
28