Jenway 4510 User Manual
Page 19
16
Interfacing (continued)
The RS232 communications parameters on the computer or printer need to be set to match those of
the Model 4510, as detailed below:
1200 Baud
9600 Baud
7 Data Bits
8 data bits
Odd Parity
OR
No parity
1 Stop Bit
1 stop bit
Setting of these options is detailed in Section 3.6.6.
The Model 4510 supports both hardware (CTS/RTS) flow control and software XON/XOFF flow control.
Pressing the PRINT key outputs from the RS232 interface.
Sending an ASCII “D” to the 4510 causes a printout of the current displayed reading plus sample
number.
Sending an ASCII “C” causes a printout of the last calibration parameters.
Sending an ASCII "P" causes a printout of the stored readings.
6.3 Keypad Emulation
Keypad remote control using RS232 interface:
7
- Instrument On / Standby / Escape
1
- Calibrate / Memory Clear
9
8
- Up Arrow
2
- Down Arrow
4
- Left Arrow
6
- Right Arrow
3 or 5
- Enter / Store
451 050/REV A/03-03