Jenway 4510 - Manual (Page 17)

Section 4
Maintenance
4.1 General
The Model 4510 is designed to give optimum performance with minimum maintenance. It is only
necessary to keep the external surfaces clean and free from dust. To give added protection when
the unit is not in use the unit should be disconnected from the mains supply and covered with the
optional dust cover (060 406). For longer term storage or re-shipment it is recommended that the
unit be returned to the original packing case.
All conductivity cells should be thoroughly rinsed after use and stored in deionised water. Do not
attempt to clean the surface of the plates as this could result in damage to the black platinised
surface.
14
Section 5
Optional Accessories
5.1 Optional Accessories
060 406 Dust cover
037 701 Printer supplied with roll of thermal paper, serial connection lead, power supply,
power connection lead (UK) and pouch
037 801 Interface cable kit
050 002 Serial communication software (3½” disk)
Conductivity Cells
027 113
Conductivity Cell K=0.1
027 114 Conductivity Cell K=1 (plastic covered)
NOTE: The cells listed below are glass free and epoxy bodied.
027 211 Conductivity Cell with ATC K=0.1
027 212 Conductivity Cell with ATC K=1
027 213 Conductivity Cell with ATC K=10
Calibration Standards
025 138
1413µS Standard (500ml)
025 156 12.88mS Standard (500ml)
025 164 84µS Standard (500ml)
025 139 10µS Standard (500ml)
025 165 1382ppm TDS Standard (500ml)
5.2 Spares
027 013 Conductivity Cell K=1
037 702 Paper roll, thermal
021 030 UK 230V power supply
021 031 European 230V power supply
021 032 US 115V power supply
021 033 230V leaded power supply
451 050/REV A/03-03