American Dryer Corp. AD-75V - Manual (Page 39)

35
10. Reversing basket (tumbler) dryers should never be operated with less than a 50 lb (22.67 kg) load (dry
weight), since the load’s weight affects basket (tumbler) coast time during a direction reversal command.
It is important that the basket (tumbler) come to a complete stop prior to starting in opposite direction.
a. Microprocessor Models
1) Spin and dwell (stop) times are not adjustable in the Automatic Mode and have been preprogrammed
into the microprocessor controller (computer) for 150-seconds spin time in forward direction,
120-seconds in the reverse direction and a 5-second dwell (stop) time.
2) Spin and dwell (stop) times are adjustable in the Manual (timed) Mode.
b. Dual Timer Models
1) Both dwell (stop) time and basket (tumbler) spin time are adjustable. (Refer to the illustration on
page 45.)
11. Check to insure that ALL setscrews (i.e., basket [tumbler] drive, idler, etc.) are tight.
K. PREOPERATIONAL INSTRUCTIONS
1. To start the dryer:
a. Microprocessor Controller (Computer) Dryers...
1) Light emitting diode (L.E.D.) display will read “REAdY” (meaning no cycle in progress).
2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key “E”)...
a) The dryer will then start (rotate).
3) L.E.D. display will now show “Cycle In Progress” and “Cycle Status” meaning that the dryer is in
the drying cycle (dry mode for 30 minutes) and count downwards in minutes.
NOTE: Pressing keyboard (touch pad) key “A” “B” “C” “D,” or “F” will also start the dryer. The six
(6) preprogrammed drying cycles “A” through “F” have been stored in the microprocessor
controller (computer) memory. Refer to the Programming Manual supplied with the dryer for
more specific operating instructions.
NOTE: The dryer can be stopped at any time by opening the main door or by pressing the “STOP”
red key. To restart the dryer, press the “START” green key or a preprogrammed cycle key
(i.e., “E”).
NOTE: Selection (settings) changes can be made at any time during the drying cycle by pressing the
“STOP” red key twice. The L.E.D. display will return to “REAdY” at which time a new cycle
selection can be made.