Alamo Swingtrim - Manual (Page 90)

OPERATION
SWINGTRIM 03/09 Operation Section 4-14
© 2009 Alamo Group Inc.
OPERA
T
ION
Never Leave the mower unattended while the head is in the raised
position. The mower could fall causing serious injury to anyone who
might inadvertently be under the mower
. (SBM-4)
BOOM ARM ASSEMBLY
• Inspect condition of each arm section weldment
• Ensure all pins are in place.
• Ensure all bolts and screws are properly
installed.
• Check condition of bushings at boom pivot
points.
• Ensure each hydraulic cylinder is installed and
retained correctly. Ensure the proper size pins
are used to retain the cylinders in place and are
secured properly. OPS-B- 0022_H
SICKLE BAR INSPECTION
• Inspect blade and bolts for looseness and
excessive wear. Make sure the unit is
securely blocked up when crawling
underneath or set on ground before doing
maintenance. Replace damaged and worn
blade to keep unit operating properly.
• Ensure hydraulic cylinder is installed and
retained correctly. Ensure the proper size
pins are used to retain the cylinder in place
and are secured with pins.
• Ensure hydraulic lines are properly connected
to the hydraulic valve and cylinder. Check for
hydraulic leaks along hoses and fittings. DO
NOT use your hands to check for oil leaks.
Use a piece of heavy paper or cardboard to
check for hydraulic oil leaks.
• Inspect the condition of the skid shoe and
hardware. OPS-B-0060
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
(SG-20)