Connecting the implement to tractor, Do not tighten the nut at this stage, Connecting the implement to tractor -10 – Alamo Swingtrim User Manual

Page 86: Operation, Opera t ion

OPERATION

SWINGTRIM 03/09

Operation Section 4-10

OPERA

ION

6. CONNECTING THE IMPLEMENT TO TRACTOR

Unbolt the upper halves of the yoke and fit them either side of the tractor’s top hitch bracket with the 3/4”
UNF nut and bolt provided. If the tractor has only one top hitch position, the bolt will replace the existing
top hitch pin. If more than one location is available mount the yokes through an alternative position as it will
make it easier to put the machine on and take it off the tractor.

Do not tighten the nut at this stage.

Start tractor only when properly seated in the Tractor seat. Starting a

tractor in gear can result in injury or death. Read the Tractor operators

manual for proper starting instructions.

(SG-13)

Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and
hose connections. Relieve hydraulic pressure before performing maintenance or repairs.
Use gloves and eye protection when servicing hot components. Contact with a hot surface
or fluid can cause serious injury from burns or scalding.

(SG-34)

Always shut the Tractor completely down, place the transmission in park, and set the

parking brake before you or anyone else attempts to connect or disconnect the Implement

and Tractor hitches.

(S3PT-15)

Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.

(SG-21)

All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards,
Gearbox Shields, PTO integral shields , and Retractable Door

Shields should be used and maintained in good working condition. All safety
devices should be inspected carefully at least daily for missing or broken
components. Missing, broken, or worn items must be replaced at once to reduce
the possibility of injury or death from thrown objects, entanglement, or blade
contact.

(SBM-18)