Detcon FP-100 - Manual (Page 9)

Model FP-100
FP-100 Instruction Manual Rev. 0.0 Page 5 of 30
This terminal board includes connectors for the following:
J1 4-Pin Connector – Modbus Out (Wireless Transceiver Option)
J2 6-Pin Header – Wireless Transceiver Programming Header
J3 8-Pin Beau Connector – used for battery operation or display interface dependant on sensor configuration
J4 4-Pin Connector – Modbus In
J5 6-Pin Connector – used for Display interface with battery/wireless configurations
J6 4-Pin Connector – Sensor connections
J7 4-Pin Connector – Auxiliary power in and mA out.
J8 6-Pin Connector – Wireless Transceiver
J9 5-Pin Header – Terminal Board Programming
The Model 100 Display Terminal Board does not provide test points for measuring the milliamp (mA) output.
The mA output is available at J7.
1.5 Model 100 Series Display (Optional)
The Model 100 Series Display is a 4-digit LED display that provides a direct display of the sensor readings. In
units that are ordered with the optional display, the display is mounted directly onto the J3 Beau connector of
the Display Terminal Board so the display can be easily seen through the J-box window. The display
automatically identifies the ITM, the sensor type, and range. This factory installed option must be ordered
along with the sensor assembly.
Figure 10 Model 100 Series Display
Fault Codes are generated by the 100 series sensors, but these fault codes cannot be visualized unless the
sensor incorporates a display. With the display option, fault codes are displayed as “Fxx” where xx is the
code. Fault Codes are described more in depth in Section 5 Troubleshooting Guide.
1.6 Wireless Transceiver and Battery Pack (Optional)
The FP-100 has the option to operate on a wireless network with the addition of a wireless transceiver and
battery pack. These options allow the sensor to be remotely mounted without the need for external wiring.
These options are factory installed. Contact Detcon for more information on these options.