Detcon FP-100 - Manual (Page 24)

Model FP-100
FP-100 Instruction Manual Rev. 0.0 Page 20 of 30
6. Install the new terminal board using the four 6-32 screws removed in step 5.
7. If the unit has the Model 100 Display Terminal Board, ensure that the jumper on the Display Terminal
Board is set properly (Refer to section 2.6.1 Model 100 Display Terminal Board Settings).
8. Re-connect the sensor connector to the terminal board and all other connections removed in step 4.
9. Reconnect the power connector to the terminal board.
10. Re-install the 100 Series Display, if one was installed.
11. Reinstall the junction box cover, and restore power to the sensor.
12. Check operation of sensor assembly. (see section 2.7 Initial Start Up)