Delmhorst Instrument F-2000 - Manual (Page 6)

CHANGE THE SET-POINT
h To change the set-point value press the set-point key
$
.
The meter will display the current set-point value.
h To scroll forward to a higher value, hold the set-point key
$
while the current value is displayed and scroll to the
set-point value desired.
h To scroll backward through the set-point values, press and
release the set-point key
$
. Within one second press and
hold the set-point decrease key
#
.
h Continue to hold the set-point decrease key
#
and the
set-point value will decrease.
h When scrolling in either direction, release the key to stop
at your desired set-point.
If the meter reads a %MC value higher than that of the set-
point, a buzzer will sound.
INFORMATION ABOUT
YOUR READINGS
The meter will accumulate up to 100 readings in memory.
After all 100 readings are “stored” it will continue to dis-
play the number of readings, the average, and the highest as
a reminder that the memory is full. It will not add new read-
ings until the memory has been cleared.
h To add a reading to the sum of all the previously stored
readings, release the Read key within 2 seconds. To avoid
storing a reading, keep the Read key depressed until the
electrode/prod is no longer in contact with the hay.
Readings below 6% will be displayed as .0 and readings
above 40% will be displayed as a flashing 999. Neither of
these types of readings will be added to your accumulated
readings.
4
F-2000 owners manualB&W_F-2000 owners manual out 1/11/13 11:31 AM Page 6