DeFelsko PosiTector PC v.1.1 User Manual
Page 11
10
Calibration Memory
When measuring a particular part with a specific powder, it is often
convenient to be able to store any unique calibration adjustments made
for that application. Then, if you return to that part, the corresponding
Cal setting can be conveniently and quickly restored.
A Cal setting is any of the three calibration adjustments (pg. 8). The
PosiTector PC always displays the current calibration setting (ex. Cal
3) in the upper right corner of the display.
The gage reverts back to its factory default Cal 1 setting after a Reset
(pg. 13) or if the user deletes all calibration settings (below).
-Creates a new calibration setting using the next available number
(Maximum of 9). By default, these new Cal settings are initially created
with the gage's factory settings as indicated with the symbol that
appears at the bottom of the display.
-Loads an existing calibration setting. Use the (-) or (+) buttons to scroll
the List box until the desired setting appears, then press
(.:::.
.
-Removes a calibration setting completely from the list. That Cal
number can be reused later with the "New" command.
-Sends a list of all Calibration Settings to the IR printer using the gage's
built-in IR port.
Cal Memory
New
Open
Delete