Catskill Craftsmen 51563 - Manual (Page 7)

3/4” pin
STEP 6
Take the 2 front braces and tap/insert one 3/4” steel pin into each
of both braces until seated. About 3/8” will stick out when seated.
OK if loose.
3/4” pin
5/8” #8 Screw
1 1/2” pin 1/2” #4 Screw
7/8” Truss Head Bolt
STEP 7
A. Tap/insert one 1 1/2” pin
into each end of both doors.
DON’T OVERDRIVE PINS!
Pins should stick up about
1/2” when seated. O.K. if
loose.
B. Attach the door spacer
to the left door with 5/8” #8
screws. The spacer has a
space at the top to allow
magnet clearance and is
almost flush with the bottom
of the door.
C. Attach the magnet plate
(may be stuck to the magnet!)
with the small flat head screw
to the top of the right door.
Bumps toward wood.
D. Attach door handles with
two 7/8” truss head bolts.
Not Used
Not Used
Right Door
Inside View
Left Door
Inside View