Catskill Craftsmen 51537 - Manual (Page 5)

STEP 2
Glide Support Assembly
5/8” #7
1 1/4” #8 5/8” #7
5/8” #7
The glides look almost alike;
however, they are stamped
CR for cabinet right and CL
for cabinet left.
Left Side
Front
Right Side
Front
The “L” brackets are attached to the Glide Support using the large slot in the “L” bracket.
The Hole will be used to attach the table top.
Flush with back
Flush with back
Top of “L” Bracket should be even with the top of the glide support
Note: Glide holes sometimes change, just make
sure the cabinet glides are flush with the back
of the glide supports & pilot holes will line up -
only 2 holes are used!
Decide at this point if you want the handle/towel bar on the right or the left side of the cabinet as
side panels are interchangeable. At this point the metal glides will determine left side/right side once
installed.